32ibrex BalloonSolid ColorThree-Point 29. Metallic Silver0201 31 760129" When injecting gas with the precision inator (low-pressure injection device), pull upwards while holding them approximately 20 cm away from the inlet (lm valve) as shown in the gure.(2) How to inject gas with the precision inator (low-pressure injection device)[Cautions in handling the Three-Point balloon]SIDE ZOOM VIEWEND ZOOM VIEW[Cautions in handling the Three-Point balloon](1) Cautions when connecting balloons *When connecting 3 balloonsBefore injectionAs shown in the gure, align the balloons so that the connecting points (lm valves) are aligned and piled on top of each other.Be careful not to have two connecting points (lm valves) as shown in the gure, otherwise it won’t possible to inject gas.The above cautions apply before injecting gas.After injecting the gas, it is not a problem if two or more connecting points (lm valves) are placed on top of each other.After injectionBefore injectionAfter injectionForcefully push down on the polyolen (double-sided tape) as shown in the gure to prevent the connecting point being detached.58.5cm23inchSuitably inflated wrinkle sizeDouble-sided tape of φ18 mm is attached to all ends for connecting.SIZEinated cm × cminated inch × inchgas(liter)lift ability (gram)29"69×58.527.2×2319.07.6●Double-sided tape※The size was measured at the center of the tape.Three Point Balloon69cm27.2inch
元のページ ../index.html#32